Right, weird problem over the last two days. We even resorted to trying to get through on the PTC help line but gave up.
One of the guys creo2 installs is doing this weird thing when you go to open a previously made drawing. All the views and annotations (notes and dimensions) have become invisible and impossible to turn back on.. They are there because you can mouse over them plus some random axis are visible where each of the views should be. If I open the drawing on my machine it opens up fine.
So this is also complicated a little bit by the fact that we had just installed windchill on his machine the week earlier and we were using configs provided by PTC. He was working offline on these drawings that were previously not created in windchill... Not sure if the Windchill part is relevent but windchill is part of the story and with the trouble we have had with it, nothing would surprise me.
-So to simplify things we uninstalled creo2 from his machined and reinstalled it (without setting windchill up) and pointed it back to where his config files live... Result: Same invisible drawing issue
-We then point Creo to a random folder to start in that contains none of our settings: Result: drawings open up fine
-Copied one of the other users config folders over and pointed it to that.... Result: Worked fine, views, notes and dimensions visible (apart from dropping out the drawing format but just tweaked that config setting and all good). Until Creo2 crashed then back to the same problem!
So we are stuck.... Any suggestions?