Quantcast
Channel: PTC Community : Unanswered Discussions - Modeling
Viewing all articles
Browse latest Browse all 2891

SWEEP OR SURFACE MODELLING(Tongue and groove joint)

$
0
0

Hi,

 

I'd like to know how to give tongue and groove fit on plastic parts. I've attached a assembly where you can find the parts with tongue and groove fit. The matter is I've created tongue and groove fit in the cabinets but the fit is not as expecting the groove after it butts the other cabinet should have 0.5mm clearance all around which i have but as you can see from the

picture there is a 0.13mm gap between the parts and in some places and i can't have it can anyone please tell how to do it. In the front cabinet i created tongue using Sweep command and in Rear cabinet i created groove using surface offset and solidify because sweep wasn't able to create groove all over.  can anyone advise how to do this.

 

Thank youc.png@


Viewing all articles
Browse latest Browse all 2891

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>