We have some older drawings that have been saved with format version 2.3. We have revised the format file to change the company logo, address and replace Pro/Engineer with Creo under the titleblock. In older versions/builds of Wildfire and Creo, when we opened an older file it would pull in the format that was saved with the drawing. Since we have upgraded to Creo 2.0 m220 last week, we are seeing Creo pull in the latest, version 2.4, format but not completely. Both logos are overlaid on each other, the old address is still there and Creo has replaced Pro/Engineer. It is very strange and frustrating.
Has anyone else seen this weird behavior with Creo 2 m220?