New to the PTC community, and looking for an answer about hole call-outs on drawings. I have a sold model with UNC threaded holes on it, and when create a drawing I can get the callouts to show up, but the leader line is not attached to the bolt hole in the standard drawing format which is used by other drafting programs. (Where the leader has and arrow pointing toward center of circle, but touching outside of circle). Instead I get an arrow that is inside the bolt hole. Is there any way to change this so I get arrows/leaders which follow the standard for detail drawings? Also, how do I add cross hairs and center points for bolt holes to the drawing. I'm using Creo 2.0, and have searched through my books and resources, and scoured through the program itself, but have been unable to find anything.
Thanks for any help.