Hi
I am using Creo 3.0 as you can see by the attached picture below there is some text (MK2) on the right support bracket. I then saved a mirrored copy for the left bracket however, the text is not correct as I need the text to read right-to-left opposite the original text which reads left to right.
I have tried a number of ways of mirroring the text with no luck I was wondering if anyone has another options I could try. Thx.
A better way of describing what I am looking for is I would like the text to read the same on both sides of the bracket.
As you can see when I try to add text to the left side the text is not correct.