Hello all, ever since the new text editor arrived in Creo 3 I have had a niggling problem. I cannot figure out how to edit the value of a parameter in a drawing table cell when more than 1 appear in that cell. If there is only 1 parameter per cell then its easy, select the cell, you see the parameter value highlight, right click & a menu appears, towards the bottom you will see 'edit value', job done. But, if you have 2 parameter values in a cell then you see different behaviour, click the cell & both values highlight as before, but when you right click, there is no 'edit value' option in the menu that appears. This is a pain in the backside for me, i control the value of quite a few parameters via a drawing table. I can do this for 99% of them, there are just a few that i cannot change because i cannot figure out how to edit them, I have to open the parts where these parameters live & edit the values there. Before Creo 3, I did not have this small but niggling problem.
Regards
John