This morning I was informed that the 1st model I released in Creo 4 (as an assembly) wasn't readable by Powermill. We have been releasing direct Assembly models because Powermill now has the capability to directly import Assemblies from Creo. Unfortunately it appears this doesn't work in Creo 4.
Next I tried exporting an IGES. There were no options that opened up at export. When I clicked on Customize there wasn't any box to export curves. When I round tripped the IGES sure enough the curves did not come back in.
We always send out our models assembled together.
At this point it appears this isn't possible.
Would there be any way to cure these issues? I looked at the config options and at this point I don't see anything that would help.
Clik here to view.
