Hello,
Whenever I create a model, and add dimensions to it, PTC does not seem to save the exact value. For instance, I dimenesioned a hole to .375 inches. When I enter it, the dimension value changes to .38 . When I click on it to edit it again, it comes up .375 . This is normal, I know. The problem comes when I save the model and quit Creo. When I come back to the model, the dimension value read .38 inches, but when I click to edit it, it still comes up .38 inches. Creo seems round off the dimensions after I save the model and come back to it.
This is a very concerning issue that I can not figure out. I have to manually change all the dimesion values that go past three decimal places. Please advice me if you know what is going on. Thanks in advance!